Keeping your vehicle well-maintained is extremely important because it enhances the longevity of your vehicle and keeps it looking brand new for an extended period. Always remember that preventive maintenance is the way to go because it’s always less costly to fix something beforehand than doing it later.
The following are some of the easiest car maintenance procedures that you can perform to keep your vehicle in good working condition, along with minimal expenses.
Effortless DIY Car Maintenance Procedures
- Air Filter
According to a well-known company offering services such as wheel alignment in Sydney, you’ll be needing an air filter at an interval of every 12,000 miles or 12 months – whichever is earlier. You can either get your air filter replaced by a professional mechanic or you can do it yourself via the below-mentioned process:
- Firstly, you need to open the hood of your vehicle and then you’ll be able to find a rectangularly-sized black box with metal clips fastened on the sides. In case you don’t find any traces of a black box, don’t forget to consult your vehicle’s owner manual.
- Once you find the black box, proceed to open up the casing and inspect the condition of the air filter present inside the same. If the filter looks old & dirty, then it’s time to replace the same.
- Eliminate the old filter and insert the new one in the same manner as the earlier one was installed.
- Now close the box casing and fasten the metal clips.
If you want to enhance the longevity of your vehicle’s air filter, then you can clean it from time to time using a compressed air can.
- Spark Plugs
In case you notice that your vehicle engine isn’t working efficiently as it should, then it could be because of the spark plug. Spark plugs can either wear out over time or get covered in debris – if maintenance is not carried out properly.
Spark plugs need to be changed every 30,000 miles, but you can check your car manufacturer’s recommendations on the same via your owner’s manual.
- Kick-off by opening up the hood of your vehicle. You’ll be able to locate the spark plugs pretty easily. These plugs are attached to thick rubbery wires under your car hood. The number of spark plugs that your vehicle will have will depend on the total number of cylinders present inside your vehicle engine.
- Proceed to remove only the first spark plug and then install a new one. Then continue the same process for the next one. Perform the replacement process one by one, so that you can maintain the recommended order.
- Make sure that you don’t over-tighten the spark plugs.
For more DIY suggestions, don’t hesitate to contact our team of expert mechanics right away.